Advanced Materials, Processing and Testing Technology II

Erscheinungsjahr 2021
ISBN: 978-3-0357-1740-2
Verlag: Trans Tech Publications

Buch, Englisch, 410 Seiten, Format (B × H): 170 mm x 240 mm, Gewicht: 830 g

This collection contains papers from the 2020 2nd International Conference on Advanced Materials, Processing and Testing Technology (AMPTT 2020, May 23-24, 2020, Guangzhou, China) that present results of scientific researches and engineering decisions in the area of materials science and development of materials processing technologies.

Autoren/Hrsg.

Fang, Dajing

Kuang, Tao

Fachgebiete

• Technische Wissenschaften Maschinenbau | Werkstoffkunde Technische Mechanik | Werkstoffkunde
• Technische Wissenschaften Verfahrenstechnik | Chemieingenieurwesen | Biotechnologie Verfahrenstechnik, Chemieingenieurwesen
• Technische Wissenschaften Maschinenbau | Werkstoffkunde Produktionstechnik

Inhaltsverzeichnis

Preface
Chapter 1: Properties and Processing Technologies of Steel and Alloys
Microstructure and Mechanical Properties of W-High Entropy Alloy Composite by Hot Swaging
Analysis of the Crack of 304 Stainless Steel and Improvement Measures
Analysis of Microstructure and Properties of High Strength Steel for Vehicle Axle
High-Throughput Characterization of Composition and Performance of Titanium Alloys Based on Nanoindentation Technology and EPMA
Influence of Mould Slenderness Ratio on the Solidification of Heavy Ingots by Numerical Simulation
Quantitative Characterization of Heat Treatment Response in a Single Crystal Nickel-Based Superalloy
Effect of Tempering Process on Microstructure and Mechanical Properties of Low Alloyed Cast Steel
Study on Fatigue Crack Growth of Laser Melting Deposited 12CrNi2 Alloy Steel Based on XFEM
Microstructure and Mechanical Properties of Low Alloy Ultra-High Strength Steel Microalloyed with Cerium
Influence of Riser Necking Ratio and Taper on the Solidification of Heavy Ingots by Numerical Simulation
Research on Deformation Prediction Method of Laser Melting Deposited Large-Sized Parts Based on Inherent Strain Method
Research on Springback during Hot Stamping with Uniform and Local-Thickened Sheet Blanks
Experimental and Numerical Analyses of Tubular Electrohydraulic Forming Process
Effect of Annealing Temperature on Microstructure and Properties of Cold Drawn Tube
The Studies of Irradiation Hardening and RIS on IASCC of Reactor Internals Bolts
Yield Behavior of Tube Hydroforming and it’s Effecti on Hollow Component Manufacturing
Chapter 2: Surfaces and Special Coatings
The Coatings Formation and Characteristic of a Low Pressure Thermal Plasma Torch
Preparation of WC/Ni Flexible Cloth Coating by Vacuum Brazing
R