E-Book, Englisch, 176 Seiten
MEFORM 2018
E-Book, Englisch, 176 Seiten
ISBN: 978-3-0357-3297-9
Verlag: Trans Tech Publications
Format: PDF
Kopierschutz: 0 - No protection
Autoren/Hrsg.
Fachgebiete
Weitere Infos & Material
Preface, Scientific Committee
Chapter 1: Light Metals and Light Alloys, Properties and Processing Technologies
Mechanical Properties and Microstructure of the Magnesium Alloy Mg-6.8Y-2.5Zn-0.5Al Produced by Casting and Hot Rolling
Application and Research Twin Roll Casting-Extruding Process for Production Longish Deformed Semi-Finished Products from Aluminum Alloys
Preparation of Novel Al-Er Master Alloys in Chloride-Fluoride Melt
Closed Die Forging of Mg-Al-Zn-Ca-Y Alloys
Development of an Innovative and Quality-Focused Production Technology for Magnesium Wire
Determination of the Hot Cracking Tendency of a Twin-Roll Cast AZ31 Magnesium Alloy by Means of Gleeble Tests
Asymmetric Twin-Roll Casting of an Al-Mg-Si-Alloy
Physical Modeling Technological Regimes of Production Deformed Semi-Finished Products from Experimental Aluminium Alloys Alloyed by Scandium
Chapter 2: Latest Trends in Forging Technology
Experimental Evaluation of Cold Forging Lubricants Using Double-Cup-Extrusion-Tests
Manufacturing of Long-Length Rods of Ultrafine-Grained Ti-Ni Shape Memory Alloys
Closing of Shrinkage Cavities by Means of Open-Die Forging
Development of a Quenching-Partitioning Process Chain for Forging Components
Chapter 3: Numerical Simulation of Technological Processes
Robustness - Practice Report: Make Forming Processes more Stable
Novel Approach for the Determination of the Taylor-Quinney Coefficient
Modelling of Cooling and Recrystallization Kinetics during Self-Annealing of Aluminium Coils
Experimental Investigations of Bulge Formation for Burnishing on Plain Surfaces
Chapter 4: Current Trends in the Processing the Steel and Non-Ferrous Metals
Investigating the Influence of Bending Parameters on the Springback Behavior of Ultra-High Strength Spring Strips
Automation Tool for Quality Assurance of Long Products
Improvement of Manufacturing Technology for Thin-Walled Pipes Made of Copper Alloys
Evolution of the Microstructure of the Copper Alloy (DIN-ECu-57) in the Deformation Zone in the Process of Pressing Conform
Effect of Cooling and Isothermal Holding on the Amount of Martensite/Austenite (M/A) Constituents, Microstructure and Mechanical Properties of Microalloyed Pipeline Steel
Optimization of Tooling Design for Hot Mandrel Bending of Pipe Elbows