Buch, Englisch, 218 Seiten, Format (B × H): 170 mm x 240 mm, Gewicht: 510 g
2nd International Conference on Advanced Manufacturing and Materials (ICAMM 2018)
Buch, Englisch, 218 Seiten, Format (B × H): 170 mm x 240 mm, Gewicht: 510 g
ISBN: 978-3-0357-1404-3
Verlag: Trans Tech Publications
Autoren/Hrsg.
Fachgebiete
Weitere Infos & Material
Preface
Chapter 1: Properties and Processing Technologies of Steel and Alloys
Wear Resistance Improvement of Cold Work Tool Steel by Fine Shot Peening
Precipitation Characterization and Mechanical Behavior in Novel DP Steels
Effect of Nickel Content on Mechanical Property and Microstructure for Sulfide Stress Corrosion High-Strength Steel
Influence of Deep Rolling Process Parameters on Surface Residual Stress of AA7075-T651 Aluminum Alloy Friction Stir Welded Joint
Effects of Deep Rolling on Surface Residual Stress and Microhardness of JIS SS400 MIG Welding
Effect of Solution Treatment Temperature on Microstructure and Mechanical Properties of Al-5.1Zn-2Mg-0.1Ti (wt. %) Produced by Squeeze Casting
An Empirical Model for Prediction of Residual Stress Based on Grinding Forces
Grain Refinement of Pure Magnesium Using Nonlinear Twist Extrusion
Research on the NC Machining and Simulation for Spiral Bevel Gears of Half-Spread-Out Helix Modified Roll
Effect of Cold Rolling and Annealing Temperature on the Characteristics of Cu-28Zn-1.1Bi Alloy Produced by Gravity Casting
Chapter 2: Materials and Processing Technologies in Biomedical Engineering
Investigation on the Anticorrosion Property of the MnCaP Coating on a Mg-Zn-Ca Alloy
Design and Manufacturing of Nasal Conformer
Lithography-Based Ceramic Manufacturing (LCM) for Dental Applications
Microstructure and Characteristic of Biomedical Titanium Alloy Based on Picosecond Laser Micromachining
Chapter 3: Properties and Processing of Functional Materials
Anodization of Zirconia Nanotubes for Lead (II) Adsorption
Fabrication of Energy Materials by a Functional Electrochemical Mold
One-Pot Preparation of Physical Hydrogel-Based Photonic Crystal
Ultra-Sensitive H2S Gas Sensor Based on WO3 Nanocubes with Low Operating Temperature
Submerged Electrical Arc Discharge for Nanoparticles Fabrication Using Carbon-Based Electrodes
Patterned Magnetorheological Elastomer Developed by 3D Printing
Chapter 4: Polymers and Composites
Effect of Type of Fiber on Inter-Layer Bond and Flexural Strengths of Extrusion-Based 3D Printed Geopolymer
Study of Antibacterial Activity of Nanosilver-Polypropylene Composite against Contaminated Bacteria in Molasses
Improvement on Dispersion of Carbon Nanotubes in Polymer Matrix by Using the Solvent with a Low Boiling Point
Influence of Binder Saturation Level on Compressive Strength and Dimensional Accuracy of Powder-Based 3D Printed Geopolymer
CFRP Bonding Pre-Treatment with Laser Radiation of 3 µm Wavelength: A Robust Solution for Industrial Applications
Investigation on the Properties of the Brake Friction Materials for Oil Driller
Enhanced Comprehension of the Continuous Fusion Bonding Process of Multi-Material Structures