Diffusion in Solids and Liquids III

Selected, peer reviewed papers from 3rd International Conference on Diffusion in Solids and Liquids, Mass Transfer - Heat Transfer - Microstructure & Properties - Nanodiffusion and Nanostructured Materials, 4 – 6 July 2007, Algarve - PORTUGAL
Erscheinungsjahr 2008
ISBN: 978-3-908451-51-8
Verlag: Trans Tech Publications

Buch, Englisch, 860 Seiten, Format (B × H): 170 mm x 240 mm, Gewicht: 1800 g

This special issue contains selected peer-reviewed papers which were presented at the Third International Conference on Diffusion in Solids and Liquids (DSL-2007), held at the Hotel Pestana Alvor Praia, Algarve, Portugal during the 4th-6th July, 2007.

Autoren/Hrsg.

Öchsner, Andreas

Murch, Graeme E.

Fachgebiete

• Technische Wissenschaften Maschinenbau | Werkstoffkunde Technische Mechanik | Werkstoffkunde

Inhaltsverzeichnis

Committees
Preface
Phase Stability in Hydroxyapatite / Barium Titanate Piezo Bioceramics
Effect of Bond Coat Diffusion on Adhesion Behaviour of Hard Alloy Powder NiCrBCSi (Fe) Coatings Thermally Sprayed on 60CrMn4 Steel
A Calorimetric Study on the Precipitation of T1 Phase during the Ageing of an Al-Li-Cu-Zr Alloy
Investigation of the Effects of GP Zones Formation on the Properties of AA2090 Alloy
Synthesis of Fe3O4 Nanoparticles Prepared by Various Surfactants and Studying their Characterizations
Analysis of the Time-Dependent Heating on the Natural Convection from a Vertical Open Ended Porous Cylinder
Sonochemical Synthesis of SnO/ZnO Nano-Composite: The Effects of Temperature and Sonication Power
Designing Cryogenic Vapour-Cooled Current Leads
Magnetically Stabilized and Fluidized Beds: Heat and Mass Transfer
Analytical Solution of Unsteady Heat Diffusion within a Porous Copper Layer Deposited on Alumina Substrate and Subjected to a Moving Laser Beam
Growth Kinetics of Al-Si-Fe Intermetallics during Hot Dipping of Steel
Production of Electrical Steel by Hot Dipping in Aluminium
Microstructure Characterization by EBSD of Hot Rolled High-Silicon Steel
The Enhanced Kinetics of Precipitation Effects in Ultra Fine Grained Mg Alloys Prepared by High Pressure Torsion
The Clustering of Cu Atoms in Neutron Irradiated Reactor Pressure Vessel Steels Studied by Positron Annihilation
Modeling of Flow and Transport Processes Occurred in a Typical Polymer Electrolyte Membrane Fuel Cell (PEMFC)
Limits to N-Type Doping in Ge: Formation of Donor-Vacancy Complexes
Co Anomalous Growth Kinetics of the CoSi Reaction Layer in a Si/System
Intrinsic Diffusivities and Modeling of the Diffusion Multiples
Electro-Diffusion in Multicomponent Ion-Selective Membranes; Numerical Solution of the Coupled Nernst–Planck–Poisson Equations
Experimental and Numerical Study on Vapor Condensation of Wet Flue Gas in Chimney
Dynamic and Equilibrium Swelling of Biodegradable Starch-Based Superabsorbent Polymers
Experimental Values of Diffusion Coefficients of Organic Compounds in Water
Effect of Temperature and Volume Changes on Effective Diffusivities of Sucrose and NaCl during Osmotic Dehydration of Vegetable Tissue
Numerical Study of Propane-Air Mixture Combustion in a Burner Element
Concentration Dependent Diffusion in Building Materials – Application of Different Methods
Anomalous Diffusion during Water Absorption in Porous Building Materials – Experimental Evidence
Influence of Burner Geometry on Flame Characteristics of Propane-Air Mixture: Experimental and Numerical Studies
Systematics of Grain Boundary Diffusion and Solute Segregation in Copper Poly- and Bicrystals
Metal Oxides Interaction with Reducing Gas in Bubble Ore Melt
About Forecasting Durability of Particles of Iron Powders and Sintered Materials
Boundary Conditions in the Diffusion of Fluids in Swelling Polymers
Effect of Synthesis Temperature on the Morphology of ZnO Nanoparticles Obtained via a Novel Chemical Route
Investigation of Reaction Conditions on Alcohol-Thermal Synthesis of ZnO Nanoparticles
An Investigation on the Mechanism of TiC+Al2O3 Formation in the Combustion Synthesis of the Mechanically Activated TiO2-Al-C System
An Investigation on the Mechanism of TiC+Al2O3 Combustion Synthesis via Mechanical Activation of Double Phases in TiO2-Al-C System
Calculations of the Effective Thermal Conductivity in a Model of Syntactic Metallic Hollow Sphere Structures Using a Lattice Monte Carlo Method
Thermal Conductivity Enhancement of Compact Heat Sinks Using Cellular Metals
A Model of Single Molecule Magnet Behavior of the [CuIILTbIII(hfac)2]2 Cluster
Oxygen Isotope Exchange between Gaseous Phase Enriched with 18O Isotope and Nanocrystal Oxides LaMnO3+d Obtained by Severe Plastic Deformation
Mechanical Damping of the Snoek Peak in Tantalum – Oxygen System
Structure of Nitrided Layer Formed on Austenitic Stainless Steel by a New Gas Nitriding Process
Optimization of Intermittent Hot Air Drying of Mango (Mangifera Indica L.)
Nitrogen Diffusion in the Nb-2.0wt%Ti Measured by Mechanical Spectroscopy
Nitrogen Diffusion in the Nb-1.0wt%Zr Measured by Mechanical Spectroscopy
Oxygen Diffusion in Superconducting Oxides
Thermodynamical Behaviour of PdSe2 while Subjected Isothermally to High Pressure – Volumetric Level Analysis
Thermodynamical Behaviour of PdSe2 while Subjected Isothermally to High Pressure - Axial Level Analysis
Measurement of Aluminium Oxide-Film Thickness: Barrier Oxide Film and Oxide Porous Layer
Diffusion Brazing of Single Crystalline Nickel Base Superalloys Using Boron Free Nickel Base Braze Alloys
Effects of Mg Additions on Surface Morphology and Corrosion Resistance of Hot-Dipped Zn Coatings
Determination of Concentration Dependent Diffusion Coefficients of Carbon in Expanded Austenite
Point Defects Characterization in Quenched d-Ni2Si as Deduced from Isothermal Magnetic Susceptibility Measurements
Growth Kinetics of Fe Boride Layers: Application of a Diffusion Model
Application of Artificial Neural Network for Prediction of Heat Treated Sintered Steels Properties
Prediction of Martensite Formation Start Temperature in Steels Using Artificial Neural Networks
Austenite Formation Temperature Prediction in Steels Using an Artificial Neural Network
Influence of P/M Distaloy AE Steel Porosities and Nitriding Process Parameters in Diffusion and Configuration of Nitrided Layers Through Advanced Liquid Salt Bath Nitriding Process
The Effect of Microstructure Heterogeneity on Fatigue Property of Powder Metallurgy Steels
Influence of the Transition to Nanoscaled State on Electrochemical Properties of LaMnO3+d Oxide
Effect of Thermal Gradient on Solidification Microstructure in the Ni-Base Single Crystal Superalloy CMSX10
Microstructural Analysis of Compressive Zr62Cu17Ni13Al8 Bulk Amorphous Alloy
Thermal Diffusivity of TiAlNb and AlNi Alloys - The European IMPRESS Project
Long-Range Diffusion of Hydrogen in Solid-Solution PdCe Alloys as Deduced from Absorption Experiments
Dominant Factor for the Occurrence of a Steam Explosion
Evaluation of Transmission Conditions for Thin Reactive Heat-Conducting Interphases
Finite Element Verification of Transmission Conditions for Thin Reactive Heat-Conducting Interphases
Numerical Study of the Inlet Conditions Influence on Laminar Plane Wall Jets
Mass Transfer Analysis during Osmotic Dehydration of Eggplant Using Binary Solutions of Sucrose and Sodium Chloride
Cross Interdiffusion Coefficients in Nickel- and Iron-Based Ternary Alloys
Exploration of the Transition from Harrison Type-A Kinetics to Type-B Kinetics Regimes in Grain Boundary Diffusion
Visualization of the Vacancy-Wind Effect Occurring in Chemical Diffusion and Ionic Conductivity in Solids
Diffusion Kinetics Analysis of Cation Diffusion in YSZ and LSGM
Theoretical Studies of Diffusion Kinetics in Austenite
Finite Element Modelling of Oxygen Diffusion and Segregation at Interfaces in Ag-MgO Composites: Parametric Studies
Interfacial Reactions during the Dissolution of Titanium in Liquid Iron
Parametric Analyses of the TROI Experimental Results by Using the TEXAS-V Code
Defect-Induced Photoluminescence of Powdered Silica Glass
Mass Transfer Kinetics in the Desulphurisation of Pig Iron with CaO and CaC2
Kinetic Description of the Mass Transfer in Ladle Metallurgy Operations
Estimation of the Rate of Hydrogen Penetration in a Welded API 5L Steel Pipe
Mössbauer Spectroscopy Studies of Grain Boundaries in Nanostructured Metals
Effect of Doping, Composite Geometry and Diffusion Annealing Schedules on the Structure of Nb3Sn Layers in Nb/Cu-Sn Wires
Kinetics Parameters of Atomic Migration and Diffuse Scattering of Radiations within the F.C.C.-Ni–Al Alloys
Atomic-Ordering Kinetics and Diffusivities in Ni–Fe Permalloy
Al-Li Surface Alloying in the Electrolytic Method
Investigation of Homogenization Treatment in Al- Li- Cu- Zr Alloys
Effect of Antioxidants and Atmosphere on the Phase Formation and Microstructure of In Situ MgO-Al2O3 Spinels
Formation and Decomposition of Sol-Gel Synthesized Aluminum Titanate Nano Powders at the Presence of Fe2O3 Additive
Effect of Colloidal Silica and Nano Boehmite Mixture on Reaction Sintering, Microstructure and Physical Properties of Tialite
Nonclassical Properties of Molecular Diffusion in Liquids and Dense Gases
Nanoparticle Friction Force and Effective Viscosity of Nanosuspensions
Diffusion of Refractory Elements in Ni—X—Y (X, Y: Co, Re, Ru, W) Ternary Alloys
Diffusion-Evaporation Studies of Binary Mixtures in Capillary Tubes
Chronoamperometric Determination of Diffusion Coefficients for Borohydride Anions in Sodium Hydroxide Solutions
Effect of Sodium Borohydride on the Hydrogen Diffusion in MmNi3.6Mn0.4Al0.3Co0.7 Hydride Electrode
Wagnerian Scaling Diffusion Kinetics
On the Features of Ultramicroelectrodes
Isothermes of Surface and Grain Boundary Tension of Cu-Based Alloys with Sb, Sn, In
Simplification of Ensemble Averaged Two-Phase Flow with Heat and Mass Transfer Equations for Boiling in a Channel
Microstructure Evaluation of Solid-Solution in Fe-Cu Immiscible Alloy System
Synthesis of ZnO Nanoparticles via Sol-Gel Process Using Triethanolamine as a Novel Surfactant
MnO-C Interaction – Thermodynamic Modelling of Phase Equilibria
Ternary Interdiffusion in L12-Ni3Al with Ir Alloying Addition
Evaluation of the Coverage Pattern on the Fracture Surface of Bi-Embrittled Cu Grain Boundaries by Means of Auger Electron Spectroscopy
The Influence of Quenching Baths on Grain Boundary Wetting Transition in Sn–25 at% In alloy
Effect of Si on High-Temperature Oxidation of Steel during Hot Rolling
High-Temperature Oxidation of Fe- Si Alloys in the Temperature Range 900-1250°C
Diffusion of 8Li Short-Lived Radiotracer in Li Ionic Conductors of NaTl-Type Intermetallic Compounds
Thermal-Mechanical Responses of Ti-6Al-4V during Orthogonal Cutting Process
Mass Transfer Coefficients during Steel Decarburization in a RH Degasser
Effect of the SiO2/Si Interface on Self-Diffusion in SiO2 Upon Oxidation
Modelling of Stable Fission Gases Diffusion in UO2 Nuclear Fuel
Computational Study of Heat Transfer in Honeycomb Structures Accounting for Gaseous Pore Filler
Study of Distribution of Impurity Atoms in Metallurgical Macrodefects
Evolution of the Enriched Layer at the Oxide/Metal Interface during Oxidation of Recycled Steels with Copper and Copper+Nickel Residuals
The Influence of Deep Cryogenic Treatment after Supersaturation of Al 4.7% Cu Alloy on Transformation during Ageing. Studies of Dilatometry, DSC, Hardness and XRD
The Influence of Deep Cryogenic Treatment on Transformation during Tempering of Quenched D2 Steel. Studies oF XRD, Structures, DSC, Dilatometry, Hardness and Impact Energy
Coupled FEM-BEM Approach for Axisymetrical Heat Transfer Problems
Diffusion of Refractory Elements in Ternary Iron Alloys
Investigation of Sulfur Transition through Metal-Slag Phase Boundary in Natural Moving Conditions
Special Session: Heat and Mass Transfer in Porous Media
Diffusion of Water in Chestnut Fruits during Drying and Rehydration Processes at Different Temperatures
Drying of a Low Porosity Product (Carrot) as Affected by Power Ultrasound
Reduction of Solids in Leachate Streams by Membrane Bioreactors: Mass Transfer Topics and Fouling Problems
Comparison between Maxwell-Stefan and Nernst-Planck Equations to Describe Ion Exchange in Microporous Materials
Numerical Modelling of the Heat and Mass Transfer in a Channel with Hygroscopic Walls
A New Approach to Measure Diffusion Coefficients at Different Temperatures – A Simple Experiment
Experimental Study of Free Convection from a Vertical Flat Plate in Porous Media
Liquid Chromatographic Method for Quantifying Atrazine Extracted by Supercritical Extraction
Heat and Mass Transfer Porous Medium Saturated with Compressible Fluid with Boundary Domain Integral Method
Development of Porous Ceramics for Gas Burners
Modeling of Transport Phenomena in a Fuel Cell Anode